logo

Ribbon Holder

Ribbon bow hair comb

Here is a free tutorial on making a cute container to hold string, ribbon, wool or cord, which feeds through for tangle free easy access.

Materials:
Box (large enough to comfortably hold your ribbon)
Wooden ball with hole (available from craft or hardware supply stores)
Clear drying super glue
Paints and paint brushes

Instructions:
Paint a face on your wooden ball. First sketch outlines lightly with pencil as a painting guide. A paint brush makes a great holder while you paint your ball, as you can slide it onto the thin end of the brush, and as it widens towards the tip it holds your ball. Using a fine tipped paint brush, paint in the face details. You could make a number of boxes for different strings and paint a family of different faces! Allow to dry by resting the two ends of the paintbrush on two objects so that the head is not touching anything.

Ribbon holder

Get a pretty box to hold your string. Tall cylinder boxes look great. I found a small square one, but would have preferred to use a larger one. It needs to be large enough for your ribbon or cord to fit comfortably inside to move around freely. Mark the center on the underside of the lid. Use a ruler and place it from one corner to the opposite corner and make a pencil mark around the center area. Do the same on the other angle and where the pencil crosses you have your center mark. Make a hole the same width as the hole in the wooden ball. I used a small round file which did the trick quite nicely. A drill would be great if you had one.

Ribbon holder

Now stick the end of a paintbrush through the hole. Put a ring of superglue around the underneath hole of the wooden head. Guide it over the end of the paintbrush and stick it down firmly against the box lid. The paintbrush helps guide it into perfect position plus helps no glue from going into the hole. Quickly remove the paintbrush however, so it doesn't become glued with the rest!

Ribbon holder

Put the lid to one side and allow the glue to dry 100%. Once dry, feed through the end of your ribbon, place the ribbon wheel in the box and close the lid. There you have it. You can now pull out some ribbon, with ease as you please.

Ribbon holder